Cisco CRS-1 - Carrier Routing System Router Migration Manual page 171

Chapter 3 Cisco CRS-3 Carrier Routing System Router Command Changes
show controllers egressq group drr
To display group information of the Deficit Round Robin (DRR) profile table, use the show controllers
egressq group drr command in EXEC mode.
Syntax Description
max
min
location node-id
Defaults No default behavior or values.
Command Modes EXEC
Command History Release
Release 4.0.0.T
Release 4.0.1
Release 4.0.2
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes the proper
task IDs. If you suspect user group assignment is preventing you from using a command, contact your
AAA administrator.
Task ID Task ID
drivers
Examples
The following example shows how to use the show controllers egressq group drr command:
RP/0/RP0/CPU0:router# show controllers egressq group drr max location 0/6/cpu0
Queue Max DRR Profile Table
----------------------------------
Index | Value (bytes)
OL-13669-03
show controllers egressq group drr {min | max} location node-id
Modification
This command was introduced.
No modification.
No modification.
Operations
read
0 | 0
1 | 88
2 | 176
3 | 264
4 | 352
5 | 440
6 | 528
7 | 616
Cisco CRS-1 Carrier Routing System to Cisco CRS-3 Carrier Routing System Migration Guide
Maximum limit of the DRR profile table.
Minimum limit of the DRR profile table.
Egress queue manager location.The node-id argument is entered in
the rack/slot/module notation.
show controllers egressq group drr
3-11