Cisco CRS-1 - Carrier Routing System Router Migration Manual page 182

show controllers egressq statistics
show controllers egressq statistics
To display the egressq statistics for a specific location in the egress queue manager, use the show
controllers egressq statistics command in EXEC mode.
Syntax Description
location node-id
Defaults
No default behavior or values.
Command Modes
EXEC
Command History Release
Release 4.0.0.T
Release 4.0.1
Release 4.0.2
Usage Guidelines To use this command, you must be in a user group associated with a task group that includes the proper
task IDs. If you suspect user group assignment is preventing you from using a command, contact your
AAA administrator.
Task ID Task ID
drivers
Examples
The following example shows how to use the show controller egressq statistics command:
RP/0/RP0/CPU0:router# show controller egressq statistics location 0/3/cpu0
Egressq Statistics
--------------------------------------------------
egressq ASIC version: 2
egressq ASIC state: Normal
plimasic link0 output packets: 34650
plimasic link0 output bytes: 6500662
plimasic link1 output packets: 0
plimasic link1 output bytes: 0
cpuctrl input packets: 25750
cpuctrl output packets: 1609269
cpuctrl output bytes: 3221287392
pse input packets: 1618173
egressq OOB drops: 0
Cisco CRS-1 Carrier Routing System to Cisco CRS-3 Carrier Routing System Migration Guide
3-22
show controllers egressq statistics location node-id
Modification
This command was introduced.
No modification.
No modification.
Operations
read
Chapter 3 Cisco CRS-3 Carrier Routing System Router Command Changes
Egress queue manager location.The node-id argument is entered in
the rack/slot/module notation.
OL-13669-03