Cisco CRS-1 - Carrier Routing System Router Migration Manual page 114

Downgrading your Cisco CRS-3 Carrier Routing System 16-Slot Line Card Chassis Back to a Cisco CRS-1 Carrier Routing
System 16-Slot Line Card Chassis
Command or Action
Step 9
do show controllers fabric rack-status all
detail
Example:
RP/0/RP1/CPU0:router(admin-config)# do show
controllers fabric rack-status all detail
Step 10
do show controllers fabric fabric-backpressure
summary
Example:
RP/0/RP1/CPU0:router(admin-config)# do show
controllers fabric fabric-backpressure summary
Step 11
no controllers fabric rack 1 install-mode
Example:
RP/0/RP1/CPU0:router(admin-config)# no
controllers fabric rack 1 install-mode
Step 12
commit
Example:
RP/0/RP1/CPU0:router(admin-config)# commit
Step 13
do show controllers rack-status all detail
Example:
RP/0/RP1/CPU0:router(admin-config)# do show
controllers rack-status all detail
What to Do Next
When all chassis in the multishelf system are operational and communicating with each other, it is time
to continue system configuration, as described in the documents in the
page
Troubleshooting Tips
For troubleshooting information, see the documents described in the
page
Example
The following example shows commands to enable power to the newly installed CRS-3 Fabric Card:
RP/0/RP0/CPU0:router#admin
RP/0/RP0/CPU0:router(admin)#config
RP/0/RP0/CPU0:router(admin-config)#no hw-module power disable loc 0/SM0/SP
RP/0/RP0/CPU0:router(admin-config)#commit
Cisco CRS-1 Carrier Routing System to Cisco CRS-3 Carrier Routing System Migration Guide
2-16
Chapter 2 Downgrading Your Cisco CRS-3 Carrier Routing System Router Back to a Cisco CRS-1 Carrier Routing
1-86.
1-86.
Purpose
Displays the status of all racks and additional information
for racks in installation mode.
• Wait for the status in the Rack in Install and Rack out
of Install columns to change to UP for all planes.
Displays the backpressure status for all racks.
The status for the row labeled "Rack 1: All Groups
•
Received? :" should be "Yes."
Modifies the target configuration to change the Rack 1
configuration to normal mode.
Commits the target configuration to the router running
configuration.
Displays the status of all racks in the system.
In a properly operating system, the rack status for all
•
racks should be Normal, and the server status should be
Present.
"Related Documents" section on
System Router
"Related Documents" section on
OL-13669-03