Cisco CRS-1 - Carrier Routing System Router Migration Manual page 51

Chapter 1 Migrating to a Cisco CRS-3 Carrier Routing System
•
•
Restrictions
None.
SUMMARY STEPS
1.
2.
3.
4.
5.
6.
7.
8.
DETAILED STEPS
Command or Action
Step 1
admin
Example:
RP/0/RP0/CPU0:router#admin
Step 2
configure
Example:
RP/0/RP1/CPU0:router(admin)#configure
Step 3
controller fabric plane 0 shut
Example:
RP/0/RP1/CPU0:router(admin-config)# controller
fabric plane 0 shut
Step 4
controller fabric plane 1 shut
Example:
RP/0/RP1/CPU0:router(admin-config)# controller
fabric plane 1 shut
OL-13669-03
The control network must be set up as described in the
Cisco CRS-3 Carrier Routing System" section on page
The single-chassis system that is being migrated does not have to be powered down.
admin
configure
controller fabric plane 0 shut
controller fabric plane 1 shut
commit
end
Repeat Step 3 through Step 6 for each fabric plane.
show controllers fabric plane all
Cisco CRS-1 Carrier Routing System to Cisco CRS-3 Carrier Routing System Migration Guide
How to Migrate to a Cisco CRS-3 Carrier Routing System (8-Slot)
"Prerequisites for Upgrading to a
1-2.
Purpose
Places the router in administration EXEC mode.
All commands listed in this procedure should be
•
entered on the pre-existing single-chassis system.
Places the router in administration configuration mode.
Shuts down the first fabric plane in the system.
In an 8-slot CRS-1 router, we have 4 fabric nodes, or
•
Fabric Controller cards numbered 0/SM0/SP to
0/SM3/SP. Each Fabric Controller card has two planes.
So for an 8-slot CRS-1 to CRS-3 migration we will be
upgrading 2 planes at a time of the pre-existing
single-chassis system.
Shuts down the second fabric plane in the system.
In an 8-slot CRS-1 router, we have 4 fabric nodes, or
•
Fabric Controller cards numbered 0/SM0/SP to
0/SM3/SP. Each Fabric Controller card has two planes.
So for an 8-slot CRS-1 to CRS-3 migration we will be
upgrading 2 planes at a time of the pre-existing
single-chassis system.
1-41