Powering Up The Replaced Fabric Card; Booting Up The Newly Migrated Cisco Crs-3 Fabric - Cisco CRS-1 - Carrier Routing System Router Migration Manual

Chapter 1 Migrating to a Cisco CRS-3 Carrier Routing System

Powering up the Replaced Fabric Card

This section describes how to enable power back to the Fabric node, and verify that node is moved to
Powered state.
Prerequisites
Software Requirements
•
•
Hardware Requirements
•
•
•
Restrictions
None.
SUMMARY STEPS
1.
2.
3.
4.
5.
6.

Booting Up the Newly Migrated Cisco CRS-3 Fabric

This section describes the process for booting up the new Cisco CRS-3 fabric.
When the Cisco CRS-3 fabric node is powered on, The Route Processor (RP) will automatically boot the
new fabric. Please wait for the boot process to complete. The node will transition from state MBI-BOOT
to MBI-RUNNING as the software is being installed.
OL-13669-03
Cisco IOS XR Software Release 4.0.0.T or later release (Cisco IOS XR Software Release 4.0.2 for
multishelf nodes)
ROMMON 1.54 or later version
The LCC to be added must be prepared as described in the
Cisco CRS-3 Carrier Routing System" section on page
The control network must be operational and connected to all chassis.
The power should be off for the FCC to be added.
admin
configure
no hw-module power disable loc 0/SM0/SP
commit
Verify that power has been enabled to the Fabric Node (state is not UNPOWERED).
show platform
Node Type
<snip>
0/SM0/SP FC-140G/S(SP)
0/SM1/SP FC/S(SP)
0/SM2/SP FC/S(SP)
0/SM3/SP FC/S(SP)
<snip>
Cisco CRS-1 Carrier Routing System to Cisco CRS-3 Carrier Routing System Migration Guide
How to Migrate to a Cisco CRS-3 Carrier Routing System (4-Slot)
"Prerequisites for Upgrading to a
1-2.
PLIM State
N/A PRESENT
N/A IOS XR RUN
N/A IOS XR RUN
N/A IOS XR RUN
Config State
PWR,NSHUT,MON
PWR,NSHUT,MON
PWR,NSHUT,MON
PWR,NSHUT,MON
1-73