Administratively Enabling The Fabric Plane; Verifying Traffic Statistics On The Newly Migrated Cisco Crs-3 Node - Cisco CRS-1 - Carrier Routing System Router Migration Manual

How to Migrate to a Cisco CRS-3 Carrier Routing System (4-Slot)
When the boot process completes the node-state will be IOS-XR RUN.
RP/0/RP0/CPU0:router(admin)#show platform
Node
<snip>
0/SM0/SP
0/SM1/SP
0/SM2/SP
0/SM3/SP

Administratively Enabling the Fabric Plane

This section describes the process for administratively enabling each new Cisco CRS-3 fabric plane.
Once enabled, the fabric plane status would be "Up".
RP/0/RP0/CPU0:router#admin
RP/0/RP0/CPU0:router(admin)#config
RP/0/RP0/CPU0:router(admin-config)#no controller fabric plane 0 shut
RP/0/RP0/CPU0:router(admin-config)#no controller fabric plane 1 shut
RP/0/RP0/CPU0:router(admin-config)#commit
Verify that each of the eight fabric planes is enabled by executing the show controllers fabric plane all
command:
RP/0/RP0/CPU0:router(admin)#show controllers fabric plane all
Plane
Id
---------------------------------------------
0
1
2
3
4
5
6
7
Each plane transitions from UP -> MCAST_DOWN -> DOWN -> MCAST_DOWN -> UP. Thus each
plane will cycle through up->dn twice. This is why the up->dn counter shows 2. Similarly each plane
will cycle through mcast_dn->up twice as well and the mcast_dn->up counter shows 2.

Verifying Traffic Statistics on the Newly Migrated Cisco CRS-3 Node

To ascertain that traffic is flowing on the CRS-3 node please run the following command on both the
planes that have been migrated. Run it a few times to ensure that the counters are incrementing. The lost
or error counters should not be incrementing.
The same command should also be applied on the legacy nodes (not yet migrated) to make sure there is
no traffic lost or traffic with errored cells.
RP/0/RP0/CPU0:router(admin)#show controllers fabric plane 0 statistics detail
Total number of providers for the statistics: 1
Total received data cells: 7063
Total received unicast data cells: 4487
Cisco CRS-1 Carrier Routing System to Cisco CRS-3 Carrier Routing System Migration Guide
1-74
Type
FC-140G/S(SP)
FC/S(SP)
FC/S(SP)
FC/S(SP)
Admin Oper up->dn
State State counter
UP UP 2
UP UP 2
UP UP 0
UP UP 0
UP UP 0
UP UP 0
UP UP 0
UP UP 0
Chapter 1 Migrating to a Cisco CRS-3 Carrier Routing System
PLIM State
N/A IOS XR RUN
N/A IOS XR RUN
N/A IOS XR RUN
N/A IOS XR RUN
up->mcast
counter
2
2
0
0
0
0
0
0
Config State
PWR,NSHUT,MON
PWR,NSHUT,MON
PWR,NSHUT,MON
PWR,NSHUT,MON
OL-13669-03