Cisco CRS-1 - Carrier Routing System Router Migration Manual page 163

Chapter 3 Cisco CRS-3 Carrier Routing System Router Command Changes
show controllers egressq clients
To display the list of clients connected to the egress queue manager, use the show controllers egressq
clients command in EXEC mode..
Syntax Description
location node-id
Command Default
No default behavior or values.
Command Modes
EXEC
Command History Release
Release 4.0.0.T
Release 4.0.1
Release 4.0.2
Usage Guidelines To use this command, you must be in a user group associated with a task group that includes the proper
task IDs. If you suspect user group assignment is preventing you from using a command, contact your
AAA administrator.
Task ID Task ID
drivers
Examples
The following example shows how to use the show controllers egressq clients command:
RP/0/RP0/CPU0:router# show controllers egressq clients location 0/6/cpu0
Mon Sep 27 00:35:08.433 DST
---------------------------------------------------------------
---------------------------------------------------------------
---------------------------------------------------------------
Table 1
OL-13669-03
show controllers egressq clients location node-id
Modification
This command was introduced.
No modification.
No modification.
Operations
read
Egressq Clients
Name PID State
QOS_EA 131187
hfr_pm 98389
feature_mgr 98408
describes the significant fields shown in the display.
Cisco CRS-1 Carrier Routing System to Cisco CRS-3 Carrier Routing System Migration Guide
The egress queue manager location. The node-id argument is entered
in the rack/slot/module notation.
registers Last-State-Changed
OPEN 1 Tue Sep 14 23:24:45 2010
OPEN 1 Tue Sep 14 23:24:18 2010
OPEN 1 Tue Sep 14 23:24:16 2010
show controllers egressq clients
3-3