Booting Up The Newly Migrated Cisco Crs-3 Fabric; Administratively Enabling The Fabric Plane - Cisco CRS-1 - Carrier Routing System Router Migration Manual

How to Migrate to a Cisco CRS-3 Carrier Routing System (8-Slot)
Hardware Requirements
•
•
•
Restrictions
None.
SUMMARY STEPS
1.
2.
3.
4.
5.
6.

Booting Up the Newly Migrated Cisco CRS-3 Fabric

This section describes the process for booting up the new Cisco CRS-3 fabric.
When the Cisco CRS-3 fabric node is powered on, The Route Processor (RP) will automatically boot the
new fabric. Please wait for the boot process to complete. The node will transition from state MBI-BOOT
to MBI-RUNNING as the software is being installed.
When the boot process completes the node-state will be IOS-XR RUN.
RP/0/RP0/CPU0:router(admin)#show platform
Node
<snip>
0/SM0/SP
0/SM1/SP
0/SM2/SP
0/SM3/SP

Administratively Enabling the Fabric Plane

This section describes the process for administratively enabling each new Cisco CRS-3 fabric plane.
Cisco CRS-1 Carrier Routing System to Cisco CRS-3 Carrier Routing System Migration Guide
1-54
The LCC to be added must be prepared as described in the
Cisco CRS-3 Carrier Routing System" section on page
The control network must be operational and connected to all chassis.
The power should be off for the FCC to be added.
admin
configure
no hw-module power disable loc 0/SM0/SP
commit
Verify that power has been enabled to the Fabric Node (state is not UNPOWERED).
show platform
Node Type
<snip>
0/SM0/SP FC-140G/S(SP)
0/SM1/SP FC/S(SP)
0/SM2/SP FC/S(SP)
0/SM3/SP FC/S(SP)
<snip>
Type
FC-140G/S(SP)
FC/S(SP)
FC/S(SP)
FC/S(SP)
Chapter 1 Migrating to a Cisco CRS-3 Carrier Routing System
"Prerequisites for Upgrading to a
1-2.
PLIM State
N/A PRESENT
N/A IOS XR RUN
N/A IOS XR RUN
N/A IOS XR RUN
PLIM State
N/A IOS XR RUN
N/A IOS XR RUN
N/A IOS XR RUN
N/A IOS XR RUN
Config State
PWR,NSHUT,MON
PWR,NSHUT,MON
PWR,NSHUT,MON
PWR,NSHUT,MON
Config State
PWR,NSHUT,MON
PWR,NSHUT,MON
PWR,NSHUT,MON
PWR,NSHUT,MON
OL-13669-03