Cisco CRS-1 - Carrier Routing System Router Migration Manual page 214

show controllers (Ethernet)
PCS Rx Link DOWN
PCS Local Fault Detected
PCS Rx Local Fault Detected
PCS Rx NOT Block Locked
PCS Rx Link Status DOWN
PCS Error'd Block Counts: 0
PCS BER Counts: 0
PCS has NO Block Lock
WIS: HW In LAN Mode - No Info
XFP General Info:
=================
UDI Checking: Disabled
PHY/XFP Status: XFP Not UDI Compliant
XFP is Working as expected
XFP Info:
=========
Max Power Dissipation: 2500 mW
XFP Type: 10GBASE-LR
Vendor Name: CISCO-SUMITOMO
Vendor Part Number: SXP3101NV-C1
Vendor OUI: 0x00-0x00-0x5f
Vendor Hardware Revision: C
Vendor Serial number: ECL120701L2
Date Code (yy/mm/dd): 08/02/27
Lot Code: D0
Cisco PID: XFP-10GLR-OC192SR
Cisco VID: V02
Cisco PN: 10-1989-02
ID: XFP
Extended ID: 0x58
TX ref clock input is not required
CDP is supported
Power Level 2 (2.5W max. power)
Minimum bit rate is 9900 MBits/s.
Maximum bit rate is 10300 MBits/s.
XFP Detail Info:
================
Temp: 32.223
Tx bias: 0.0 mA
Tx power: 0.0 mW (-40 dBm)
Rx power: 0.33 mW (-24 dBm)
AUX 1: +3.3V Supply Voltage: 0x70
AUX 2: Auxiliary monitoring not implemented: 0x0
XFP Status: enabled.
laser is enabled
MOD NR is not ready
is powered off
doesn't have interrupt(s)
has LOS
data is ready
TX path is ready
Cisco CRS-1 Carrier Routing System to Cisco CRS-3 Carrier Routing System Migration Guide
3-54
Chapter 3 Cisco CRS-3 Carrier Routing System Router Command Changes
OL-13669-03