Required Tools And Equipment - Cisco CRS-1 - Carrier Routing System Router Migration Manual

How to Migrate to a Cisco CRS-3 Carrier Routing System (16-Slot)
Figure 1-1 Switch Fabric Card
Prerequisites
Before performing this task, you must first open the front cosmetic doors (if installed).
Caution Use the slide-assistance arm to slide cards from the card carrier. DO NOT LIFT CARDS BY THE
SLIDE-ASSISTANCE ARM! Rotate cards onto their vertical axes, then lift them from the bottom, using
the slide-assistance arm only as an aid for balance.

Required Tools and Equipment

You need the following tools to perform this task:
•
•
Cisco CRS-1 Carrier Routing System to Cisco CRS-3 Carrier Routing System Migration Guide
1-28
ESD-preventive wrist strap
Large Phillips screwdriver
Chapter 1 Migrating to a Cisco CRS-3 Carrier Routing System
OL-13669-03