Verifying Fabric Link Connectivity - Cisco CRS-1 - Carrier Routing System Router Migration Manual

Chapter 1 Migrating to a Cisco CRS-3 Carrier Routing System
Total received low priority unicast data cells: 4487
Total received high priority unicast data cells: 0
Total received multicast data cells: 2576
Total received low priority multicast data cells: 2050
Total received high priority multicast data cells: 526
Total transmitted data cells: 21094
Total transmitted unicast data cells: 4487
Total transmitted low priority unicast data cells: 4487
Total transmitted high priority unicast data cells: 0
Total transmitted multicast data cells: 16607
Total transmitted low priority multicast data cells: 13977
Total transmitted high priority multicast data cells: 2630
Total received correctable errored cells: 0
Total received uncorrectable errored cells: 0
Total received parity error cells: 0
Total received stomp cells: 0
Total received kill cells: 0
Total received unknown cells: 0
Total transmitted bogus cells: 4
Total transmitted statically routed control cells: 0
Total transmitted stomp cells: 0
Total transmitted kill cells: 0
Total transmitted ECI cells: 0
Total transmitted LCE cells: 0
Total unicast lost cells: 0
Total multicast lost cells: 0
Total ctb enqueue to off queue
Total non-ctb enqueue to off queue
Total incoming header error cells: 0
Total incoming data error cells: 0
Total outgoing header error cells: 0
Total outgoing data error cells: 0
Total scs ce error cells: 0
Total scs uce error cells: 0
Last clearing of "show controller fabric plane" counters 00:06:22

Verifying Fabric Link Connectivity

This section describes the commands used to check the Line Card (LC) to Fabric and Route Processor
(RP) to Fabric links for all LCs and RPs in the router (and for DRPs as well). The following commands
may be used to check the link connectivity for each LC/RP node.
IngressQ to Fabric connectivity:
show controller ingressq fabric links loc <LC/RP/DRP location>
Fabric to FabricQ connectivity:
show controller fabricq link all loc <LC/RP/DRP location>
All links should be UP. Please repeat the CLI for ALL LC/RP/DRP locations in the router.
RP/0/RP0/CPU0:router(admin)#show controllers ingressq fabric links loc 0/5/cpu0
Ingressq link state
plane-id
----------------------------------------------------.
0
0
0
0
OL-13669-03
cells: 0
link-id ADMIN-STATE OPER-STATE
0 UP
8 UP
16 UP
24 UP
Cisco CRS-1 Carrier Routing System to Cisco CRS-3 Carrier Routing System Migration Guide
How to Migrate to a Cisco CRS-3 Carrier Routing System (4-Slot)
cells: 0
AVAIL-STATE UP-COUNT
UP UP
UP UP
UP UP
UP UP
2
2
2
2
1-75