Cisco CRS-1 - Carrier Routing System Router Migration Manual page 59

Chapter 1 Migrating to a Cisco CRS-3 Carrier Routing System
A CRS-3 fabric card can be installed in any of the slots SFC0 to SFC11 (upper card cage) and SFC12 to
SFC23 (lower card cage).
Caution Use the slide-assistance arm to slide cards from the card carrier. DO NOT LIFT CARDS BY THE
SLIDE-ASSISTANCE ARM! Rotate cards onto their vertical axes, then lift them from the bottom, using
the slide-assistance arm only as an aid for balance.
Required Tools and Equipment
You need the following tools and part to perform this task:
•
•
•
Steps
To install a CRS-3 fabric card, see
Figure 1-9
1
2
OL-13669-03
ESD-preventive wrist strap
Large Phillips screwdriver
CRS-3 fabric card
Installing a CRS-3 Fabric Card
Cisco CRS-1 Carrier Routing System to Cisco CRS-3 Carrier Routing System Migration Guide
How to Migrate to a Cisco CRS-3 Carrier Routing System (8-Slot)
Figure 1-4 and follow these steps:
3
1-49