Cisco CRS-1 - Carrier Routing System Router Migration Manual page 208

show controllers (Ethernet)
DMA Strip CRC
Ignore Length Error: True
Pad Short Frames
Min TX IFG
Min RX IFG
IFG Rate Control
Hi Gig Mode
Discard Ctrl Frames: True
Enable Stats Update: True
RX Stats Int Mask
TX Stats Int Mask
Port Number
Port Type
Transport mode
BIA MAC addr
Oper. MAC addr
Port Available
Status polling is : enabled
Status events are : enabled
I/F Handle
Cfg Link Enabled
H/W Tx Enable
MTU
H/W Speed
H/W Duplex
H/W Loopback Type : None
H/W FlowCtrl type : None
H/W AutoNeg Enable: Off
H/W Link Defects
Link Up
Link Led Status
Symbol errors
Serdes version
Input good underflow
Input ucast underflow
Output ucast underflow
Input unknown opcode underflow: 0
Pluggable Present
Pluggable Type
Pluggable Compl.
Pluggable Type Supp.:
Pluggable PID Supp. :
Pluggable Scan Flg: false
XFP EEPROM
Cisco CRS-1 Carrier Routing System to Cisco CRS-3 Carrier Routing System Migration Guide
3-48
: False
: True
: 12
: 4
: False
: False
: 0x00000000
: 0x00000000
: 0
: 10GE
: LAN
: 001b.53ff.a780
: 001b.53ff.a780
: true
: 0x0c000040
: tx/rx enabled
: yes
: 9112
: 10 Gbps
: Full
: (0x0000) None
: yes
: Link up
: 255
: 14.42
: 0
: 0
: 0
: yes
: 10GBASE-LR
: Compliant
Supported
Supported
port: 0
Xcvr Type: XFP
Ext Type: 2.5 W, CDR Supported, No Tx Ref Clk input req., CLEI present,
Connector Type: LC
Ethernet Xcvr Codes: 10GBASE-LR, 10GE-FC-1200-SM-LL-L,
SONET Xcvr Codes: SDH_I_64.1
Encodeing: 64B/66B, SONET Scrambled, NRZ,
Bit Rate Min.: 9900 Mbit/s
Bit Rate Max.: 11100 Mbit/s
Link Reach 9u SM fiber: 10 Km
Device Tech.: 1310 nm DFB, No wavelength ctrl, Uncooled Xmtr, PIN detec
Vendor Name CISCO-OPNEXT
CDR Support: 9.95 Gb/s, 10.3 Gb/s, 10.5 Gb/s,
Vendor OUI: 00.0b.40
Vendor Part Number TRF5012AN-LA000
Wavelength: 1310 nm
Chapter 3 Cisco CRS-3 Carrier Routing System Router Command Changes
(rev.: 01)
OL-13669-03