Cisco CRS-1 - Carrier Routing System Router Migration Manual page 235

Carrier routing system
Hide thumbs Also See for CRS-1 - Carrier Routing System Router:
Table of Contents

Advertisement

Chapter 3
Cisco CRS-3 Carrier Routing System Router Command Changes
Within a policy map, you can give one or more classes priority status. When multiple classes within a
single policy map are configured as priority classes, all traffic from these classes at same priority level
is queued to the same, single priority queue. There is one priority queue per level in a group.
Modifying CRS-MSC-40G QoS Configurations for CRS-MSC-140G
On the Cisco CRS Series Modular Services Card 40G (CRS-MSC-40G), a priority action can be
configured with or without a police action in the same class.
On the Cisco CRS Series Modular Services Card 140G (CRS-MSC-140G), a police action must be
configured in the same class as the priority action. A class configuration that includes a priority action
but no police action is not valid. Such a configuration is rejected.
To use existing CRS-MSC-40G QoS configurations on the CRS-MSC-140G, add a police action to all
classes that have a priority action.
Priority assignment at the group level for an egress interface policy is not supported.
Task ID
Task ID
qos
Examples
The following example shows how to configure priority queuing for the policy map named policy1:
RP/0/RP0/CPU0:router(config)# policy-map policy1
RP/0/RP0/CPU0:router(config-pmap)# class class1
RP/0/RP0/CPU0:router(config-pmap-c)# priority level 1
RP/0/RP0/CPU0:router(config-pmap-c)# police rate percent 20
RP/0/RP0/CPU0:router(config-pmap-c)# class class-default
RP/0/RP0/CPU0:router(config-pmap-c)# end-policy-map
Related Commands
Command
bandwidth (QoS)
policy-map
show policy-map interface
OL-13669-03
Operations
read, write
Description
Specifies or modifies the minimum bandwidth allocated for a
class belonging to a policy map.
Creates or modifies a policy map that can be attached to one or
more interfaces to specify a service policy.
Displays the configuration of all classes configured for all service
policies on the specified interface.
Cisco CRS-1 Carrier Routing System to Cisco CRS-3 Carrier Routing System Migration Guide
priority (QoS)
3-75

Advertisement

Table of Contents
loading

This manual is also suitable for:

Crs-3

Table of Contents