Cisco CRS-1 - Carrier Routing System Router Migration Manual page 74

How to Migrate to a Cisco CRS-3 Carrier Routing System (4-Slot)
Caution Use the slide-assistance arm to slide cards from the card carrier. DO NOT LIFT CARDS BY THE
SLIDE-ASSISTANCE ARM! Rotate cards onto their vertical axes, then lift them from the bottom, using
the slide-assistance arm only as an aid for balance.
Required Tools and Equipment
You need the following tools to perform this task:
•
•
Steps
To remove an CRS-1 fabric card, see
Figure 1-12
1
2
1
2
Cisco CRS-1 Carrier Routing System to Cisco CRS-3 Carrier Routing System Migration Guide
1-64
ESD-preventive wrist strap
Large Phillips screwdriver
Removing a CRS-1 Fabric Card
Captive screw
Ejector lever
Chapter 1 Migrating to a Cisco CRS-3 Carrier Routing System
Figure 1-12 and follow these steps:
3
3 Direction of installation or removal
OL-13669-03