Cisco CRS-1 - Carrier Routing System Router Migration Manual page 203

Chapter 3 Cisco CRS-3 Carrier Routing System Router Command Changes
Driver constraints:
Min MTU: 64 bytes
Max MTU: 9216 bytes
Max speed: 10Gbps
Interface type: TenGigE
Management interface: No
Promiscuous mode: Yes
Allowed config mask: 0x27b
Cached driver state:
MTU: 1522 bytes
Burnt-in MAC address: 001d.353b.975e
Bundle settings:
Aggregated: No
Bundle MTU: 1514 bytes
Bundle MAC address: 001d.353b.975e
Port FSM state:
Port is disabled, due to an admin down condition.
Complete FSM state:
Admin down
Bundle admin up
Client admin up
Client admin tx not disabled
Port disabled
Port tx disabled
Hardware link down
IDB interface state information:
IDB bundle admin up
IDB client admin up
IDB client tx admin up
IDB error disable not set
0 Unicast MAC Addresses:
0 Multicast MAC Addresses:
0 Unicast Bundle MAC Addresses:
0 Multicast Bundle MAC Addresses:
Current Data
NP(01) Version
Structure Version
XAUI Interface
MAC addr
RX enabled
TX enabled
Obey Pause Frames
TX Pause Frames
Pause Re-TX Period : 3000000
Min Frame Len
Max Frame Len
Ignore Errors
Add CRC
Strip CRC
Ignore CRC Errors
DMA Add CRC
DMA Strip CRC
Ignore Length Error: True
Pad Short Frames
OL-13669-03
: 0003
: 2582
: B
: 00.1d.35.3b.97.5e
: False
: True
: False
: False
: 60
: 1526
: False
: True
: True
: False
: False
: False
: True
Cisco CRS-1 Carrier Routing System to Cisco CRS-3 Carrier Routing System Migration Guide
show controllers (Ethernet)
3-43