Chapter 1
Migrating to a Cisco CRS-3 Carrier Routing System
•
•
Restrictions
None.
SUMMARY STEPS
1.
2.
3.
4.
5.
6.
7.
DETAILED STEPS
Command or Action
Step 1
admin
Example:
RP/0/RP0/CPU0:router#admin
Step 2
configure
Example:
RP/0/RP1/CPU0:router(admin)#configure
Step 3
hw-module power disable loc 0/SM0/SP
Example:
RP/0/RP1/CPU0:router(admin-config)# hw-module
power disable loc 0/SM0/SP
Step 4
commit
Example:
RP/0/RP1/CPU0:router(admin-config)# commit
OL-13669-03
The control network must be set up as described in the
Cisco CRS-3 Carrier Routing System" section on page
The single-chassis system that is being migrated does not have to be powered down.
admin
configure
hw-module power disable loc 0/SM0/SP
commit
end
Repeat Step 3 through Step 5 for each fabric plane.
show platform
Cisco CRS-1 Carrier Routing System to Cisco CRS-3 Carrier Routing System Migration Guide
How to Migrate to a Cisco CRS-3 Carrier Routing System (8-Slot)
"Prerequisites for Upgrading to a
1-2.
Purpose
Places the router in administration EXEC mode.
•
All commands listed in this procedure should be
entered on the pre-existing single-chassis system.
Places the router in administration configuration mode.
Disables the power to the specified fabric plane in your
single-chassis system.
Commits the target configuration to the router running
configuration.
•
This step brings up the previously shutdown plane,
which is now configured to use the FCC-CRS-3 fabric
card.
1-43