3-6 Lubrication to Needle Bar Case
Proper lubrication is necessary for keeping the machine head in good condition.
Turn off the power switch before starting any cleaning work, otherwise the machine may operate if the
start switch is pressed by mistake, which could result in injury.
Before operating the machine for the first time after unpacking or after leaving the machine without
operation for a long period of time, supply one or two drops of oil to each needle bar from the oil supply
holes of the lower cover.
• Use the Brother's specified oil (Nippon Oil, Embroidery Lube 10N; VG10) for this.
• Supplying an excessive amount of oil will cause dripping onto the material.
CAUTION
BE-1204B-BC • BE-1206B-BC
Chapter 1 Preparations of operation
W1221Q
1-13