Brother BE-1204B Instruction Manual page 36

Chapter 1 Preparations of operation
1. Pass an upper thread from the cotton stand through the hole of the thread guide right above each
cotton stand bar. Pass the thread from the back to the front hole.
The cotton stand (top view)
Front
2. Pass the thread through the upper hole of the pretension[1].
disc with your finger, and pass it from the left to the lower hole.
3. Pass the thread through the upper hole of the 2nd pretension. Push up the thread guide tension
disc[2] with your finger, and pass it from the left to the lower hole.
4. Wind the thread clockwise once around the rotary disc and place it on the spring.
5. Pass the thread through the hole of tension stand inner thread guide [3].
6. After passing the thread through the hole of tension stand lower thread guide [4], insert the thread
into the right side of the inner thread guide and pass it through the hole of the thread take-up.
7. Bring the thread back to the inner thread guide.
section.
8. Pass the thread through the hole of the wire of the needle bar thread guide [6] and pass it through
the needle eye. Pass it through the presser foot. Pass it to presser spring at the front of lower
thread guide [5].
1-16
Pass a thread in the order
indicated in the figure.
W1234Q
Insert the thread into the hole from the upper
BE-1204B-BC • BE-1206B-BC
Push up the thread guide tension