Brother BE-1204B Instruction Manual page 167

Code Error Messages
Performing the home
position detection for
E-13
the hoop position
adjustment
Y-axis home position
E-14
error
E-15
Press for restart.
Needle bar No. of the
E-16
destination is abnormal
E-17 Speed range abnormal
X-axis stepping motor
E-18
connector error
E-1A ERROR 1A
E-1B ERROR 1B
E-1C Restart perimeter
Stop while transferring
E-1D
to next repeat pattern
Remove unused
E-1E presser foot, or it may
be damaged
E-1F Presser foot down error
E-21
Area over
E-22 Area over
E-23
Area over
E-24
Area over
E-25
Area over
E-26
Area over
E-27
Area over
E-28
Area over
E-29
Area over
Error
This is displayed in case that the
machine had been shut down
while the hoop was moving and
now is started up in a mode
without the home position
detection, or in case that the
machine is started up in a mode
without the home position
detection after pressing the CAP
SW to change the hoop.
Y-axis home position error
Stop error during SSP processing
(when pressing the stop key while
the hoop is moving)
Needle bar No. of the destination
is out of range
Speed range is out of range
X-axis stepping motor connector
error
Destination coordinates error
The machine has reached the
mending stop position.
The machine stops during mask
tracing.
The machine stops while the
needle is moving between patterns
during repeat sewing.
Errors E-1C and E-1D are not displayed due to mechanical problems.
When the power is turned on, bed
can not be retracted.
Presser foot down error while
searching for home position just
after the power is turned on.
Hoop overhang (+X)
Hoop overhang (+Y)
Hoop overhang (+X, +Y)
Hoop overhang (-X)
Hoop overhang (+X, -X)
Hoop overhang (-X, +Y)
Hoop overhang (+X, -X, +Y)
Hoop overhang (-Y)
Hoop overhang (+X, -Y)
BE-1204B-BC • BE-1206B-BC
Measures
Press the to start the home position moving.
Turn the power off and on once. If the same
error occurs again, the Y-axis mechanism is
faulty.
Hoop movement restarts if you press
Press the , or turn ON the F/B switch on the
head to either side to cancel the error and set up
the needle bar setting again.
This is not usually displayed.
Turn the power off and on once after checking to
see that the connector of the X-axis stepping
motor is properly connected.
This is not usually displayed.
Tracing is cancelled if the
when the machine is stopped during mask
tracing. Press the
tracing.
This is displayed when the stop switch is pressed
while the hoop is moving. Press the
move the hoop again. (It is necessary to press
the again to start sewing.)
This is not displayed in this model.
Pattern or the needle position is out of the
embroidering area. Reset the embroidering
area on the panel or move the hoop to the
sewable position.
Chapter 9 Error code list
.
key is pressed
key to continue
to
9-3