Lubrication To Needle Bar Case - Brother BE-1204B Instruction Manual

2-6 Lubrication to Needle Bar Case

Proper lubrication is necessary for keeping the machine head in good condition.
Turn off the power switch before starting any cleaning work, otherwise the machine may operate if the
start switch is pressed by mistake, which could result in injury.
Before operating the machine for the first time after unpacking or after leaving the machine without
operation for a long period of time, supply one or two drops of oil to each needle bar from the oil supply
holes of the lower cover.
• Use the Brother's specified oil (Nippon Oil, Embroidery Lube 10N; VG10) for this.
* If this type of lubricating oil is difficult to obtain, the recommended oil to use is <Exxon Mobil Essotex SM10;
VG10>.
• Supplying an excessive amount of oil will cause dripping onto the material.
CAUTION
BE-1204B-BC • BE-1204C-BC • BE-1206B-BC
Chapter 2 Preparation of Embroidery Machine
W1221Q
2-11