For Technical Assistance Please Call Toll Fre e 1-877-4BROTHER Website: http://www.brother-usa.com/industembroidery/tech_down.aspx Rotary hook 1. Open bobbin case covers and remove bobbin cases. Use brush to remove lint build up in and around rotary hooks. Compressed air may also be used.
Note: Cover in photo has been removed for illustration of where to lubricate. For Technical Assistance Please Call Toll Fre e 1-877-4BROTHER Email: tsupport@brother.com http://www.brother-usa.com/industembroidery/tech_down.aspx Weekly Maintenance Oiling 1. Remove rubber dust plugs to the right of each head.
For Technical Assistance Please Call Toll Fre e 1-877-4BROTHER Website: http://www.brother-usa.com/industembroidery/tech_down.aspx Knives 1. Remove the two rear screws and remove the needle plates. 2. Clean any thread and lint around the moving and fixed knives. 3. Re-install needle plates. Email: tsupport@brother.com...
Page 4
1. Lubricate the front lower shaft bushing by adding oil to the red hole for each head. For Technical Assistance Please Call Toll Fre e 1-877-4BROTHER Email: tsupport@brother.com http://www.brother-usa.com/industembroidery/tech_down.aspx Monthly Maintenance Oiling 1. Lubricate the rear lower shaft bushing by adding oil to the red hole for each head.
Page 5
BE-1206. 2. Remove the right end cover by removing the two lower screws and loosening the one upper screw. For Technical Assistance Please Call Toll Fre e 1-877-4BROTHER Email: tsupport@brother.com http://www.brother-usa.com/industembroidery/tech_down.aspx Monthly Maintenance Greasing Cam grooves 3. Remove the right end cover by removing the two lower screws and loosening two upper screws.
Page 6
[1]. 6. Unscrew the two adjusting bolts [4] and detach the jump part stepping motors [5]. For Technical Assistance Please Call Toll Fre e 1-877-4BROTHER Email: tsupport@brother.com http://www.brother-usa.com/industembroidery/tech_down.aspx Monthly Maintenance Greasing Cam grooves continued 7. Grease the cam groove of the work clamp cams.
Page 7
13. Grease the cam groove of the thread take-up driving cams. 14. Attach the head front covers R [9]. For Technical Assistance Please Call Toll Fre e 1-877-4BROTHER Email: tsupport@brother.com http://www.brother-usa.com/industembroidery/tech_down.aspx Monthly Maintenance Greasing Cam grooves continued 15. Install left end head cover.
For Technical Assistance Please Call Toll Fre e 1-877-4BROTHER Website: http://www.brother-usa.com/industembroidery/tech_down.aspx Driving shaft 1. Unscrew four screws fixing the table cover L, and remove the table cover L. 2. Grease the intermediate gears. 3. Attach the table cover L. Email: tsupport@brother.com...
Page 9
For Technical Assistance Please Call Toll Fre e 1-877-4BROTHER Website: http://www.brother-usa.com/industembroidery/tech_down.aspx 3 Month Maintenance Lower gear 1. Unscrew the 4 flat head screws fixing the bed cover B, and remove the bed covers B. 2. Grease the lower gears. 3. Attach the bed covers B.