Lubrication To Needle Bar Case - Brother BE-0901E-AC-PC Instruction Manual

Chapter 2 Preparation of Embroidery Machine

2-6 Lubrication to Needle Bar Case

Turn off the power switch before starting any cleaning work, otherwise the machine may operate if the
start switch is pressed by mistake, which could result in injury.
Proper lubrication is necessary for keeping the machine head in good condition.
2-6
CAUTION
Before operating the machine for the first time
after unpacking or after leaving the machine
without operation for a long period of time,
supply one or two drops of oil to two sections at
the top and the bottom of each needle bar. (See
the left figure.)
BE-0901E-AC-PC
W1570
BE-1201B-AC-PC
W1570
BE-0901E-AC-PC• BE-1201B-AC-PC
Note)• Use the Brother's specified embroidery
machine oil (Nisseki Embroidery Lube No.
10 or the equivalent).
• Supplying an excessive amount of oil
will cause dripping onto the material.