Setting Of Mending - Brother BE-1204B Instruction Manual

Chapter 5 Setting

Setting of Mending

Details of mending can be set in case of a thread breakage.
! Contents of each setting item are as described below.
Item Contents
For setting a mending end point (number of stitches before a thread breakage) within the
range of 1 ~ 10.
This function is previously set to 1 stitches upon shipments.
For setting whether to reset a thread breakage error automatically.
This function is previously set to
For setting whether to stop embroidering temporarily at the mending end point
For setting a thread trimming method using the
breakage error. (This setting is effective only once after resetting the error.)
! Refer to "Mending" (→ Page 6-5).
1. Press .
2. Select by pressing
3. Press .
5-12
For resetting an error automatically
For resetting an error manually
For stopping embroidering at the mending end point
For stopping embroidering temporarily at the mending end point and then starting all
heads automatically
For not stopping embroidering at the mending end point and continuing embroidering
Manually trim the lower thread immediately after resetting a thread breakage error if
feeding by stitch back is long (i.e., 40 to 50 mm or more) in this mode.
Set the thread trimming method to
For trimming both upper and lower threads
For trimming the lower thread only
For not trimming any thread
.
W0609Q
W0612Q
BE-1204B-BC • BE-1206B-BC
(Manual) upon shipments.
.
immediately after resetting a thread