Brother BE-1204B Instruction Manual page 31

! ! ! ! For embroidering with flat hoop/sash frame (upper position)
[3]
1. Attach four hexagon socket head cap screws to each of table parts R [1], M [2](six head models
only), and L [3] from the back.
2. Insert the table backing plate [4] of each table into the table backing rubber on the table support
Middle [5].
3. Adjust the height of the table support Front [6] to be even with the upper surface of the bed.
4. Tighten all hexagon socket head cap screws firmly.
5. Attach four(three in four head models) thumb bolts to the lower front steel pipe of the leg section.
Fasten the table and the leg section using table stays (4 pcs(3pcs in four head models)) [7].
[2]
BE-1204B-BC • BE-1206B-BC
Chapter 1 Preparations of operation
[5]
[4]
[6]
[1]
[7]
W1228Q
1-11