Brother BE-1204B Instruction Manual page 136

Chapter 6 Operation of Machine
Manual operation of the mending
Setting or cancellation of the mending can be specified during the suspension of embroidering with
individual heads regardless of thread breakage.
• End positions of the mending can not be individualized according to head.
If there are more than one heads with the mending function ON, the head position which was set
first will be the end position for all heads.
• To cancel the end position, turn ON the mending function (the lamp illuminates green) to all the
heads sewing at that time.
1. While the embroidering is suspended with the head to set the mending, flip up its thread tension
stand switch further.
The thread tension stand lamp will illuminate green and the mending will be set ON.
To turn OFF the mending, flip up the thread tension stand switch again to turn off the lamp.
2. Bring back the needle position by pressing
back position and the suspended position will be the subject to the mending.
Case of Mending usage
No.1 Stitch
Sewing
direction
Stand by
position A
1. Disable MENDING function of No. 3 at the standby position A.
(This position should be the mending end position.)
2. Pressing or
Disable MENDING function of No. 2 at the position B.
(The position B does not become the end position; the position A remains the end position.)
When enabled MENDING function of the machine head whose MENDING function is disabled:
• The thread tension stand lamp will illuminate green, and mending is executed for the machine
head.
6-6
No.2 Stitch No.3 Stitch
No.3
Disable mending
W1275Q
to move it backward.
BE-1204B-BC • BE-1206B-BC
W1259Q
or . The section between the brought
No.1 Stitch
B
Stand by
position A
No.2 Stitch No.3 Stitch
Mending
W1276Q