Brother BE-1204B Instruction Manual page 170

Chapter 9 Error code list
Code Error Messages
Lower shaft flash
E-BD
memory error
Lower shaft version-up
E-BE
error
E-BB,
ERROR BB, BF
BF
E-C1 ERROR C1
E-C2 Wiper out error
E-C3 ERROR C3
E-C4 Presser foot down error
E-C5 ERROR C5
E-C6 ERROR C6
E-C7 ERROR C7
E-C8 ERROR C8
E-C9 Embroidering start error
E-CA ERROR CA
Spindle rotation speed
E-CB
error
E-CC ERROR CC
Spindle rotation
E-CD
command sending error
Cylinder bed position
E-CE
error
E-CF ERROR CF
E-D0 Power PC board error
E-D1 Cooling fan motor stop
Power voltage upper
E-D2
limit error
Power voltage lower
E-D3
limit error
Thread trimming motor
E-D4
overcurrent
9-6
Error
Lower shaft flash memory error
Lower shaft version-up error
Lower shaft motor undefined error
Area over during embroidering
Wiper out error
Embroidering data buffer empty
Presser foot down error
Measured voltage value could not
be received form the lower shaft
motor CPU.
Voltage value could not be
transferred to the lower shaft motor
CPU.
Lower shaft error
Hook motor origin point error
Embroidering start error
No sewing permisson
Spindle rotation speed error
Shuttle thread entanglement
automatic reset
Speed command can not be
received.
Cylinder bed position error
Rated voltage value could not be
received from the lower shaft
motor CPU.
Power PC board error
Cooling fan motor stop.
Power voltage upper limit error
Power voltage lower limit error
Thread trimming motor overcurrent
BE-1204B-BC • BE-1206B-BC
Measures
This is not displayed in this model.
If the wiper is tangled with a thread, remove it.
Press the or turn on the F/B switch on the
head to either side.
Check the connection of the communication
cable of the panel. If the cable is connected
correctly , press the or turn on the F/B
switch on the head to either side. If the cable is
disconnected , turn off the power and connect the
cable.
This is not usually displayed.
Press the or turn on the F/B switch on the
head to either side to cancel the error and press
the . If the same error occurs again, there
is a possibility that the spindle is overloaded.
This is not usually displayed.
Turn the power off and on once. If the same
error occurs again, the main PCB is faulty.
This is not usually displayed.
Turn the power off and on once. If the same
error occurs again, the power PCB is faulty.
This is not usually displayed.
(1) The voltage setting is improper. -> Set it
again.
(2) Press the or turn on the F/B switch on
the head to either side. If the same error
occurs again, the power PCB or the power
supply is faulty.
Turn OFF the power. The possible causes for this
error are, troubles of the thread trimming motor,
troubles of the main PCB, and troubles of the
drive PCB.