Brother BE-1204C Technical Reference

Brother sewing machine - rotary hook support bar adjusting / replacing

Hide thumbs Also See for BE-1204C:

See also: Maintenance Schedule , Technical Reference

Title:

Adjusting / Replacing rotary hook support bar

Date:

May 27, 2008

Models:

BE-1204C/BE-1206B

Rotary Hook Support Bar

Remove

Technical Reference

1. Make sure the machine power is turned off.

2. Remove the needle plate by removing the two screws

as indicated by the red arrows.

3. Using red T-handle (4mm) wrench, turn pulley in the

direction of the arrow to 200 degrees. Note: Cover has

been removed in the photo, but this is not necessary.

4. Remove the two screws as indicated by the red arrows

and remove the rotary hook support bar. The screw

head for the left screw is located underneath.

5. Install new rotary hook support bar but leave the

screws slightly loose.

Table of Contents

Do you have a question about the BE-1204C and is the answer not in the manual?

Page 1 Adjusting / Replacing rotary hook support bar Date: May 27, 2008 Models: BE-1204C/BE-1206B 1. Make sure the machine power is turned off. 2. Remove the needle plate by removing the two screws as indicated by the red arrows. 3. Using red T-handle (4mm) wrench, turn pulley in the direction of the arrow to 200 degrees.
Page 2 Technical Reference 6. Pull the needle down, by the thread guide above the Middle thread guide needle, until it locks into place. Align the tip of the rotary hook bar behind the needle. Remove Loosen Remove Rotary Hook Support Bar Tip 7.

Be-1206b