Viewing Live Images Via Mouse Control; Displaying The [Live] Screen; Select A View; Select A Camera - JVC VR-N1600U - 16 Channel Network Video Recorder Instructions Manual

Basic Operation
Viewing Live Images via
Mouse Control
This section describes the procedures for viewing live
images by controlling the mouse.

Displaying the [Live] Screen

1
Select [Live] from the main menu
● The NVR Viewer starts up and the [Live] screen
appears.
● When the [Browse] or [Screen Setup] screen of the
NVR Viewer is displayed, click the [Live] tab.
● To exit the NVR Viewer, click the [ ] button.
[Live] Tab
View List
[Views] Section
[Live] Screen
● If you have specified the camera record settings without
closing the [Live] screen, live images may not appear
immediately after you have exited the camera settings.
In this case, Unable to connect to the server!
Reconnecting to the server or Unable to connect to
127.0.0.1:80 on the device name(camera name)!
Reconnecting to the server will appear on the [Live]
screen. (127.0.0.1:80 is the internal IP address of the VR-
N1600U/E that is currently in operation.)
Memo :
● Depending on the condition of the network circuit, it may
take some time before images from the camera are
displayed.
● Depending on the connection of the additional hard disk,
several minutes may be required for the [Live] screen to
appear.

Select a view

For details on the view settings, refer to [Screen Setup] (A
Page 54).
1
Select a view from the [Views] section, or from
the view list at the upper end of the window
Note :
● Do not switch the view frequently within a short time
interval.
● When live images do not appear on VN-C625/VN-C655,
set the password on the camera unit as well as VR-
N1600U/E again. For details on the setting procedures,
refer to the [INSTRUCRTIONS] of the camera in use and
procedures for setting the root password on the [Edit
device settings] screen in this manual (A Page 75).
● The audio setting is set to No Audio Sources when you
return from the setting screen to [Live]. Select the audio
parameters again.
[ ] Button

Select a Camera

1
Select a camera by clicking on the bar at the
upper end of the screen of the camera to select
using the mouse
● When you have selected a camera, the blue bar at the
top of each live image changes to a lighter blue tone.