Selecting The Recording Control Mode; Selecting The Manual Recording Mode; Scheduler Setting - JVC VR-N1600U - 16 Channel Network Video Recorder Instructions Manual

Selecting the Recording Control Mode

In order to record in the recording control mode, you need to
specify the scheduler settings (A Page 47), image recording
settings (A Page 49), and picture quality settings (A Page
52) in the main menu [Camera Record Setting].
1
Press and hold down the [REC CONTROL]
button while recording is stopped ([REC]
indicator is off).
● The [REC CONTROL] indicator lights up and the unit
switches to the recording control mode.
● Recording will be executed according to the camera
record settings.
Memo :
● To stop recording, press and hold down the [REC/STOP]
button during recording in a mode other than recording
control (the [REC] indicator lights up or appears blinking).
After the light of the [REC] indicator goes off, press and
hold the [REC CONTROL] button.
● To exit the recording control mode, press and hold down
the [REC CONTROL] or [REC/STOP] button.
● Depending on camera status or other circumstances, it
may take a while before recording starts after switching to
the recording control mode.
Note :
● Do not turn off the power while you are configuring the
camera recording settings.

Selecting the Manual Recording Mode

1
Press the [REC/STOP] button
● The unit switches to the manual recording mode and
starts recording from all cameras.
● The [REC] indicator lights up.
Memo :
● To exit the manual recording mode, press and hold down
the [REC/STOP] button. Upon doing so, the light of the
[REC] indicator goes off.
● To clear all recording modes, press and hold down the
[REC/STOP] button.
WARNING
LIVE/BROWSE
OPERATE ALARM
SELECT HDD
LOCK
REC CONTROL
PTZ/PRESET
FUNCTION
SERIAL
CANCEL ZOOM OUT ZOOM IN ENTER
[REC CONTROL] Button/Indicator [REC/STOP] Button
[REC] Indicator
REV
SEARCH KEY ALARM CLEAR REC/STOP STOP(PB) PLAY

Scheduler Setting

This feature lets you specify when to switch each camera to
the online mode, as well as the online/offline mode of
cameras when an event occurs.
Memo :
● When in the online mode, the camera executes recording
according to the camera record settings.
● When in the offline mode, recording is not executed
regardless of the camera record settings.
● You can specify the time zone during which e-mail alerts
are triggered when motion is detected. You can also
specify the time zone to activate automatic patrolling
(A Page 81) when using PTZ cameras.
● The minimum unit of time that you can specify is 5
minutes.
Note :
● The online/offline mode has no impact on the manual
recording, [EXT REC IN] signal recording, and emergency
recording modes.
● Even when Offline or
scheduler, the camera switches to the
[Start cameras on remote live requests](A Page 93)
under [General Settings] is enabled and live images are
displayed on the [NVR Viewer].
1
Select [Camera Record Setting] from the main
menu
2
Click the [Scheduler...] button
● The [Scheduler...] screen appears.
[Scheduler...]
Button
3
FWD
Select the camera for which you want to set a
schedule from [Camera].
SKIP
Select a Camera
is specified in the
[Camera Recording Administator] Screen
[Scheduler] Screen
mode if