JVC VR-N1600U - 16 Channel Network Video Recorder Instructions Manual page 59

Item Preset Values
DRecording Settings (Cont'd)
Enable On motion
speedup On event
When to store Always
images in Never
database
Conditionally
F
Datebase
Settings
G
Motion
Detection
Settings
Motion
Detection..
Motion Color..
Enables you to specify whether or not to execute recording in the maximum frame rate when
motion is detected or when an event occurs.
When [On event] is selected:
Specify the starting and ending events in the [Start] and [Stop] fields respectively.
The speedup recording frame rate uses the [Frame Rate] in the [Speedup Settings]A item.
Enables you to specify the recording conditions in recording control mode. If you have
selected [Conditionally], specify the following fields as well.
Always
On motion
On event
Memo :
● For details on events, refer to [Camera Input/Output Port and Events] (A Page 83).
Note :
● The [ALARM] indicator on the front panel lights up regardless of the recording status
when the motion or event specified in [When to store images in database] occurs. Press
the [ALARM CLEAR] button to turn off the light of the [ALARM] indicator.
( )seconds pre/post recordings on motion/event:
You can record images preceding and following a detected motion or event. Specify the time
interval to record in the number of seconds before and after the occurrence. (A Page 114)
Memo :
● Do not set to 0 seconds .
● If Offline is selected in [Scheduler...], images will not be recorded.
● This setting has no impact on manual recording, emergency recording, and [EXT REC
IN] recording.
^
Enables you to specify the database settings. (A Page 96)
^
Enables you to specify the two parameters for motion detection, namely [Sensitivity] and
[Motion Sensitivity]. (A Page 92)
Enables you to specify the color to be used for highlighting detected motion.
Description
:Select this check box to record images at all times.
:Select this check box to record all images for which motion has been
detected.
:Select this check box to record all images from the occurrence of an event
until the next event occurs regardless of motion. Specify the starting and
ending events in the [Start] and [Stop] fields respectively.