JVC VR-N1600U - 16 Channel Network Video Recorder Instructions Manual page 23

2
Check to ensure that the camera is detected
● After the message disappears, a list of detected
cameras is displayed.
● If all the cameras are not detected, press the [Auto
Detect] button again. If doing so does not solve the
problem, check the connection with the cameras and
the IP address of the cameras.
3
Swap the order of detected cameras
● Select SORT button using [SKIP] button and press
[16/ENTER] button. The order of detected cameras
can be sorted.
● The different types of sort buttons include the [IP],
[MAC], [CH], [MAKER], and [MODEL] sort buttons.
● Select list using [SKIP] button to select [2/D], [10/0/E].
After selecting camera, press [SKIP]] button to select
[Up], [Down]. When [16/ENTER] is pressed, the order
of cameras will be swapped.
● Deselect the check box of any camera that you are not
using.
Memo :
● The camera in the upper position of list order has the first
priority. Camera number will be registered in the list order.
4
Use the [SKIP] button to select [Entry], followed
by pressing the [16/ENTER] button
● The camera that is automatically detected is registered
in the system.
5
Use the [SKIP] button to select [OK], followed by
pressing the [16/ENTER] button
● The [Configure Device] screen appears.
6
Enter the password for the network camera
● Press the [KEY] button to display the software
keyboard. (A Page 20)
● Use the keypad to move the mouse cursor over the
software keyboard.
● Pressing the [16/ENTER] button inputs the characters
on the keyboard into the password field.
7
After password entry is complete, press [KEY]
again the close the software keyboard
8
Use the [SKIP] button to select [OK], followed by
pressing [16/ENTER]
9
Repeat the steps from 5 to 7 for every detected
camera
● The [Camera Record Setting] screen appears.