Snmp Trap Settings; Snmp User Table - D-Link xStack DES-6500 User Manual

xStack DES-6500 Modular Layer 3 Chassis Ethernet Switch User Manual
The xStack DES-6500 chassis switch incorporates a flexible SNMP management for the switching environment. SNMP
management can be customized to suit the needs of the networks and the preferences of the network administrator. Use the
SNMP V3 menus to select the SNMP version used for specific tasks.
The xStack DES-6500 chassis switch supports the Simple Network Management Protocol (SNMP) versions 1, 2c, and 3.
The administrator can specify the SNMP version used to monitor and control the Switch. The three versions of SNMP vary
in the level of security provided between the management station and the network device.
SNMP settings are configured using the menus located on the SNMP V3 folder of the web manager. Workstations on the
network that are allowed SNMP privileged access to the Switch can be restricted with the Management Station IP Address
menu.

SNMP Trap Settings

The following window is used to enable or disable SNMP traps on the Switch. There are two types of traps located on the
Switch, SNMP traps and SNMP Authenticate traps which the user may enable or disable by using the corresponding pull-
down menu. After changes are made, click the Apply button to save it to the Switch's memory.
Figure 8 - 1. SNMP Trap Settings window

SNMP User Table

The SNMP User Table displays all of the SNMP User's currently configured on the Switch.
In the SNMP Manager folder, click on the SNMP User Table link. This will open the SNMP User Table, as shown
below.
Figure 8 - 2. SNMP User Table
To delete an existing SNMP User Table entry, click the below the Delete heading corresponding to the entry to delete.
To display the detailed entry for a given user, click on the hyperlinked User Name. This will open the SNMP User Table
Display page, as shown below.
208