Hp Ultra3 Scsi Host Adapter Driver Software; Preloaded Ultra3 Drivers; Embedded Ultra3 Drivers - HP D5970A - NetServer - LCII Installation And Configuration Manual

Figure 1-11. Terminating the Last External SCSI Device
4. Terminate only the device at the end of the chain. (Use of an external
multi-mode SCSI terminator is required.)
5. Connect power cables to all external devices and to the HP Netserver.

HP Ultra3 SCSI Host Adapter Driver Software

NOTE
To use the HP Ultra3 SCSI host bus adapter, driver software must be
installed for your operating system.

Preloaded Ultra3 Drivers

If the HP Ultra3 SCSI host bus adapter was included as part of a HP Netserver
you purchased, then the appropriate HP driver has already been pre-installed by
HP and you do not need to install it.

Embedded Ultra3 Drivers

Some operating systems have embedded driver support for the HP Ultra3 SCSI
host bus adapter. To determine if the host adapter is supported by the operating
system you are using, read the operating system manual or contact the operating
system vendor for information.
13