HP D5970A - NetServer - LCII Installation And Configuration Manual page 52

[xxxxx081] Adapter initialization failure
[xxxxxx8A] Adapter initialization failure
[xxxxxx83] Adapter initialization failure
An error has occurred while the driver was setting up its internal data structures.
Verify that your adapter is supported by this version of the driver.
[xxxxx089] Unable to allocate memory
This indicates that there may be a problem with the amount of memory installed
in your system. Verify that your system has at least the minimum amount of
memory required by your operating system.
[xxxxx096] Adapter hardware initialization failure—possible resource
conflict
The driver has attempted to initialize the adapter hardware but failed. This
might suggest that an adapter resource (for example, an IRQ) conflicts with
another board installed in your system.
[xxxxx097] Unable to allocate memory
This indicates that there may be a problem with the amount of memory installed
in your system. Verify that your system has at least the minimum amount of
memory required by your operating system.
[xxxxx0af] Unable to de-allocate memory that was allocated for a target
device
Normally, this is not a serious problem, unless you get this message frequently
over a short period of time. The memory can be reclaimed by rebooting the sys-
tem.
[xxxxx0ce] Scatter/gather limit exceeded
An I/O request packet from the system contained a Scatter/Gather element list
that contained more elements than are supported by the miniport. Scatter/Gather
is a list of data segments that define the entire data transfer. Scatter/Gather is a
means to improve total data throughput. This error might be caused by a com-
46