Dos Drivers For Cd-Rom Access; Install Cd-Rom Drivers On A Dos Bootable Hard Disk - HP D5970A - NetServer - LCII Installation And Configuration Manual

10. To install additional adapters, follow the procedures from
Step 4.
11. When complete, select Continue to complete the installation.

DOS Drivers for CD-ROM Access

The CD-ROM drivers need to be installed only if DOS access to a CD-ROM
drive attached to a SCSI host adapter is required. If NetWare is already
installed, or if the CD-ROM drive is not connected to a SCSI adapter, these
drivers do not need to be copied or installed. However, you may choose to
install these drivers if you are having trouble accessing your CD-ROM from
Netware.
NOTE
You do not need these drivers for Windows NT or UNIX.

Install CD-ROM Drivers on a DOS Bootable Hard Disk

The following systems files should be modified:
• config.sys
• autoexec.bat
1. Copy the files aspi8u2.sys and aspicd.sys from the DOS directory of the
Ultra3 Family Manager Set disk to your C drive. At the DOS prompt, type
the following lines and press Enter after each line:
mkdir c:\scsi
copy a:\dos\*.* c:\scsi
2. Modify config.sys for loading aspi8u2.sys and aspicd.sys, which is
necessary for connecting a CD-ROM. Either create this file in C:\ if you do
not currently have a config.sys, or add these lines to the existing config.sys
file. Note that you may need to change the path for the drivers.
device=c:\scsi\aspi8u2.sys /d
device=c:\scsi\aspicd.sys /d:aspicd0
3. Modify autoexec.bat for loading mscdex.exe. Either create this file in C:\
if you do not currently have autoexec.bat, or add these lines to the existing
autoexec.bat file: c:\dos\mscdex.exe /d:aspicd0 /m:12
53