Installing The Driver When Unixware Is Already Installed - HP D5970A - NetServer - LCII Installation And Configuration Manual

6. If necessary, enter the DCU (Device Configuration Utility) to view/change
the UnixWare device driver configuration data.
7. Follow the on-screen instructions to continue with installation. Refer to the
UnixWare documentation and on-screen help files for help in selecting
options.
NOTE
If your installation fails, do not attempt to use the update installation
pkgadd procedure to fix the installation. Follow the instructions in
the UnixWare documentation and in this User's Guide to retry the
installation.
Installing the Driver When UnixWare
is Already Installed
To update or install the adst21 driver or adst70 driver on a system where
UnixWare is already installed, follow the instructions in this section. The
procedures are similar for UnixWare 2.1x and 7.1. Procedures that are specific
to a UnixWare version are noted when necessary.
CAUTION
Installing or updating the driver involves the following tasks, which must be
completed in the following order:
1. Back Up the Computer—Backs up the old UnixWare kernel and any other
important files.
2. Load the Package—Uses pkgadd to load the HP Ultra3 Family driver
package.
3. Modify the New System File—For computers booting from a device
connected to HP Ultra3 SCSI host bus adapter, modifies the new driver that
84
Improper or corrupt driver updates might destroy your
existing UnixWare file system. Back up all important files
before proceeding. Consult your UnixWare documentation
for proper backup procedures.