Microsoft Windows Nt Installation; Installing The Driver When Installing Windows Nt; Completing A Fresh Windows Nt 4.0 Installation From Floppy Disk - HP D5970A - NetServer - LCII Installation And Configuration Manual

3 Microsoft Windows NT
Installation
This chapter explains how to install the HP Ultra3 Family Manager Set driver
adpu160m.sys for Windows NT.
If you are performing a first time Windows NT installation, see "Installing the
Driver When Installing Windows NT" in the next section. If Windows NT is
already installed in your system, see "Installing the Driver When Windows NT
is Already Installed" on page 24.
Installing the Driver When Installing
Windows NT
The adpu160m.sys driver is not embedded on the Windows NT 4.0
installation disks (or CD-ROM) and must be added during Windows NT
installation.
Completing a Fresh Windows NT 4.0 Installation From Floppy
Disk
1. Start your system with the Windows NT Boot Disk in the floppy disk drive.
2. When prompted, insert disk #2 in your floppy disk drive. After a few
moments you will see a blue screen. To setup Windows NT now, press Enter.
3. Press S to skip auto-detection of your SCSI host adapter.
4. Press S again to specify an additional device.
5. Press Enter to select Others; insert the HP Ultra3 Family Manager Set disk
for Windows NT into your floppy disk drive.
6. Using the arrow keys, select the following driver and press Enter:
Adaptec Ultra3 PCI SCSI Controller (NT4.0)
7. To add other host adapters, press S and repeat from Step 5 for each addi-
tional adapter and insert the appropriate driver disk.
23