HP D5970A - NetServer - LCII Installation And Configuration Manual page 51

[xxxxx012] Error issuing command
[xxxxxx99] Error issuing command
The driver does not recognize the target device.
[xxxxx021] Target device protocol error
An unexpected event occurred during data transfer between the adapter and tar-
get device. Normally, this indicates a faulty or non-compliant target device.
[xxxxx022] Adapter or target device protocol error
The adapter or target device has broken the communication protocol. A badly
behaving device could cause this message to appear. Normally this is not a seri-
ous problem. If you get this message frequently over a short period of time, it
could indicate that the device or system is malfunctioning. Unplug or power
down unused devices to see if the problem persists.
[xxxxx023] Target device parity error
The driver has detected a parity error by the target device.
[xxxxx024] Data overrun or underrun
The adapter was given more or less data than the expected amount of data.
[xxxxx031] Target device queue full
The target device internal buffer is full.
[xxxxx032] Target device busy
The target device reports a Busy status. Another program may already be using
this device.
[xxxxx050] Host adapter failure
[xxxxxx9A] Host adapter failure
Your host adapter may not be properly installed or is defective. Try resetting the
adapter in the PCI slot, or try installing it a different PCI slot.
45