Installing The Driver When Netware Is Already Installed - HP D5970A - NetServer - LCII Installation And Configuration Manual

NOTE This will assign the CD-ROM to the next available drive letter,
typically D if there is only one DOS drive. If you are using MS-DOS
5.0 and do not already have mscdex.exe, you will need to either
upgrade to MS-DOS 6.0 or above, or download mscdex.exe from
Microsoft BBS or CompuServe forum.
4. Reboot your system. You are now able to access your CD-ROM drive from
the command line and from Windows.
Installing the Driver When NetWare is Already
Installed
To update or install the adpt160m.ham driver when NetWare is already
installed, follow the instructions in this section. The procedures are similar for
all versions of NetWare. Procedures that are specific to a NetWare version are
noted when necessary.
1. Make a backup copy of the old driver (if it exists) before installing the new
driver.
2. Copy the adpt160m.ham driver from the HP Ultra3 Family Manager Set
disk for NetWare into the server's startup directory (e.g., c:\nwserver,
c:\server.40) on your hard disk. This overwrites any existing version of the
driver in the directory.
NOTE For NetWare 3.12/3.2 and 4.12/4.2, the file is in \netware. For
NetWare 5.0, the file is in \netware\v5_xx.
3. If necessary, modify the load command line in the startup.ncf file so that
the proper path to the driver and all appropriate command line options are
specified. See "Loading the Driver at Server Bootup" on page 55.
The correct syntax to load the Ultra3 Family driver is
load [pathname]adpt160m [options].
Command line options are not case sensitive. Placing commas between
command line options is optional. See "Loading the Driver at Server Bootup"
on page 55 for possible values.
54