Boot The New Kernel; Using Unixware And The Host Adapter - HP D5970A - NetServer - LCII Installation And Configuration Manual

cd /etc/conf/bin
./idbuild -B
Status messages appear.
2. When the kernel has been built, type the following and press Enter after
each line (0 in -g0 is zero, not the letter O):
cd /etc/conf/cf.d
cp unix /stand/unix
cd /
shutdown -g0
3. Type y and press Enter when the computer asks if you really want to shut
down. System Is Down should appear on the screen.
The UnixWare kernel is now ready for host adapter operation.

Boot the New Kernel

To reboot the computer with the new kernel, follow these steps:
1. Follow the on-screen instructions (usually by pressing Enter) to reboot your
computer.
2. Check the bootup messages to verify that all your installed SCSI devices are
listed.
If some or all of your installed SCSI devices do not appear at this time, your
SCSI cables may be loose, or the SCSI device setup may not be complete. If so,
go back and correct any problems before proceeding.
3. Wait for UnixWare to complete bootup with the new kernel.
Refer to "Troubleshooting" on page 90 if the computer crashes or if panic
(UnixWare error) messages appear during bootup.
The updated driver for UnixWare should now be ready to use.

Using UnixWare and the Host Adapter

This section contains useful information on using UnixWare and your host
adapter.
87