HP D5970A - NetServer - LCII Installation And Configuration Manual page 14

3. Plug the internal Ultra2 or Ultra3 SCSI devices to the other cable connectors,
starting with the connector at the terminated end of the cable.
Terminated LVD SCSI Twisted-Pair Cable
NOTE
Internal Ultra2 and Ultra3 SCSI devices come from the factory with
termination disabled and cannot be changed. Proper SCSI bus
termination is provided by the terminator at the end of the LVD SCSI
cable.
4. Connect a power cable from your HP Netserver's internal power supply to
each internal SCSI device.
Connecting the SCSI Host Adapter to a Hot-Plug Cage
1. Use the point-to-point twisted-pair cable.
2. Plug one end of the twisted-pair cable to the internal LVD/SE connector.
3. Plug the other end of the twisted-pair cable to the 68-pin connector on the
hot-plug cage.
8
Terminator
Figure 1-6. Common Tray Cable Connection