HP D5970A - NetServer - LCII Installation And Configuration Manual page 78

d
Modify the mscsi file according to your hardware setup:
• If you are booting from an Ultra3 SCSI host bus adapter, make sure the
host adapter prefix for the host adapter number 0 is ad160.
• If you are not booting from an Ultra3 SCSI host bus adapter, make sure
the host adapter prefix for the host adapter number 0 is the appropriate
prefix for each device on your primary HP host adapter. See the table
above.
e
Save the file and exit the text editor.
4
Rebuild the UNIX kernel by following these steps:
a
Type the following at the # prompt and press Enter after each line:
cd /etc/conf/cf.d
./Iink_unix
Status messages appear on-screen.
b
When the kernel has been built, shut down the system by typing shutdown-
g0 and pressing Enter.
c
Turn OFF the system power when you are prompted to do so.
If you need to reconfigure your system, you may do so now.
d
Add or remove host adapters or devices as needed.
5
Boot the new kernel by following these steps:
a
Follow the on-screen instructions to reboot your system, usually by pressing
Enter.
72