HP D5970A - NetServer - LCII Installation And Configuration Manual page 84

adl60 Sdsk 0 0 0 0
NOTE Each field is separated by a tab. Do not use the spacebar to separate
fields.
The meanings of the fields are as follows:
Host
Adapter
Prefix
ad160
1
This field applies to SCO OpenServer 5 only.
• Host Adapter Prefix: Identifies the name of the host bus adapter driver. If
you are booting from an Ultra3 SCSI host bus adapter, the Host Adapter
Prefix must be adl60.
• SCSI Device Type: Identifies the type of SCSI device. For example,
Sdsk indicates that the device is a hard disk; Srom indicates a CD-
ROM drive; and Stp indicates a tape drive.
• Host Adapter Number: Identifies the SCSI host bus adapter that the SCSI
device is attached to. For example, the first Ultra3 SCSI host bus adapter
is 0, the second Ultra3 SCSI host bus adapter is 1.
• Target ID: Identifies the SCSI ID of the SCSI device.
• Logical Unit Number: Identifies the Logical Unit Number (LUN) of the
SCSI device. This field is usually 0.
• Bus: Identifies the SCSI bus that the SCSI device is attached to. For most
HP host bus adapters, the bus number is 0.
If you need to edit the mscsi file, use the vi editor. You must build a new
kernel in order for any changes to take effect (see Step 4 on page 72).
78
Table 6-1.
SCSI Host
Device Adapter
Type Number
Sdsk 0
Logical
Unit
Target
Number
ID
0 0
1
Bus
0