Configuration With Scsiselect - HP D5970A - NetServer - LCII Installation And Configuration Manual

2

Configuration with SCSISelect

SCSISelect, included with the HP Ultra3 SCSI Host Bus Adapter, enables you
to change SCSI settings without opening the computer or handling the host bus
adapter. SCSISelect also enables you to low-level format or verify the disk
media of your SCSI hard disk drives. The following table lists the available and
default settings for each SCSISelect option.
NOTE
The default settings are appropriate for most systems. Run SCSISelect
if you need to change or view current settings, or if you would like to
run the SCSI disk utilities. See the descriptions of each option starting
on page 17.
SCSISelect Options
SCSI Bus Interface Definitions:
Host Adapter SCSI ID
SCSI Parity Checking
Host Adapter SCSI Termination
LVD/SE Connectors
SE Connectors
Boot Device Options:
Boot SCSI ID
Boot LUN Number
SCSI Device Configuration:
Sync Transfer Rate (MBytes/sec)
Available
Settings
0-15
Enabled, Disabled
Automatic, Enabled,
Disabled
Automatic
Low ON/High ON
Low OFF/High OFF
Low OFF/High ON
0-15
1 0-7
160, 80.0, 53.4, 40.0,
32.0, 26.8, 20.0,
16.0, 13.4, 10.0,
ASYN
Default
Setting
7
Enabled
Automatic
Automatic
0
0
160
15