Back Up The Computer; Load The Package - HP D5970A - NetServer - LCII Installation And Configuration Manual

was loaded in the previous procedure. Loading the driver causes the driver to
become a permanent part of the new boot kernel on rebuild.
4. Rebuild the UnixWare Kernel—Rebuilds the kernel with the new driver.
5. Boot the New Kernel—Reboots the computer with the new kernel.
NOTE
Remember that UnixWare commands are case sensitive. Enter the
commands exactly as shown.

Back Up the Computer

If you have not already done so, back up all important files on the computer. See your
UnixWare documentation for proper UnixWare file system backup procedures.
1. Log in as root at the UnixWare # system prompt.
2. To back up the old UnixWare kernel, type the following and press Enter:
cp /stand/unix /stand/unix.work

Load the Package

To load the driver, follow these steps:
1. At the system prompt, type the following and press Enter:
pkgadd -d diskette1
Follow the instructions on-screen to insert the IHV HBA disk (or HP Ultra3
Family Manager Set disk for UnixWare 2.1x or UnixWare 7.01/7.1) into the
boot floppy disk drive.
2. Select the adst21 or the adst70 package from the on-screen menu and press
Enter. The package is loaded into your UnixWare operating system.
3. When the package has loaded, you may be prompted to install the disk again.
Do not reinsert the IHV HBA disk (or HP Ultra3 Family Manager Set disk for
UnixWare 2.1x or UnixWare 7.01/7.1). Instead, type q (quit) and press Enter.
4. Type mail and press Enter. The mail messages tell you if the installation was
successful.
85