Tools Required; Hp Netserver Rack Mount Parts List; Rack Configuration Tools - HP D5970A - NetServer - LCII User Manual

Chapter 8
The HP Netserver LP 2000r rack mount kit requires two EIA units of space in the
rack. Before mounting the Netserver, plan the Netserver's location in the rack
relative to other rack components. Proper placement is vital both for safety and
operating efficiency. For more information, see "Rack Configuration Tools" later
in this chapter.

Tools Required

You will need the following tools to install the HP Netserver in a 2-post rack:
• Standard Phillips screwdriver
• Marking pen or masking tape

HP Netserver Rack Mount Parts List

Ensure the rack-mounting kit provided with the HP Netserver contains the
following parts:
Table 8-1. Parts for Rack Mount Kit
Quantity
2 Flush mount brackets (one left and one right side)
2 Center mount brackets (one left and one right side)
8 Screws for Brackets (standard Phillips)

Rack Configuration Tools

The HP rack configuration tools, including white papers, are on HP's web site at
the following URL:
http://www.hp.com/netserver
At the Web site, search for the following:
• Configuration tools
• High density rack solutions
• Rack Assistant, Rack Configuration
• Order Assistant
• HP Netserver High Density Rack Solutions Overview (LP 1000r and
LP 2000r)
You can read about the tools or download copies for installation. These tools can
be used to plan a rack configuration for the components in your system.
Rack Mounting the HP Netserver (2-Post)
Description
77