Marking Rack Columns - HP D5970A - NetServer - LCII User Manual

Chapter 7

Marking Rack Columns

To make it easier to install the slides in the rack, you may want to mark the rack
columns to indicate the server placement.
Use the HP Rack Configuration Tools to determine where in the rack to mount the
HP Netserver. The tools are available at:
http://www.hp.com/netserver/support
Use a marking pen or masking tape to mark the server position on the face of the
front columns and the inside of the rear columns. The example in Figure 7-2
shows a HP System /E or /U rack.
"#" represents
the EIA unit
numbers on the
rack columns.
Third Hole
From Bottom
First Hole
From Bottom
Masking
Tape or
Marker
Figure 7-2. Marking Rack Columns
Rack Mounting the HP Netserver (4-Post)
Rear of
Mark this face of
Left
the columns with
Side masking tape
or marker pen.
Front of
Bottom of
HP Netserver
Rack
Right
Side
Rack
65