HP LC2000r - NetServer - 128 MB RAM Configuration Manual
Hp netserver lc 2000 rs/12fc /windows 2000 advanced server cluster configuration guide
Hide thumbs
Also See for LC2000r - NetServer - 128 MB RAM:
- Installation manual (186 pages) ,
- Handbook (178 pages) ,
- User manual (154 pages)
Advertisement
Quick Links
Introduction
This document defines the supported HP NetServer LC 2000 configuration with HP Rack Storage/12FC
and Microsoft Cluster Server. These configurations minimize single points of failure (SPOF), provide
maximum availability, and have been certified by Hewlett-Packard and Microsoft. This guide is
prescriptive; it describes the configurations supported by HP. Any deviance to these configurations can
result in an inoperative cluster or an operating cluster with degraded performance, hidden SPOFs, etc., and
therefore will not be supported by HP.
What's Defined in Cluster
Cluster
Type of SPUs
Installation
Number of nodes
Shared Storage
LANs:
Client LAN
Intra-cluster
(Heartbeat) LAN
HP NetServer LC 2000
with
HP Rack Storage/12FC
Windows 2000 Advanced Server
Cluster Configuration Guide
16 May 2000
(see Versions at the end of this document)
Cluster
SPUs
Local and Shared Storage
Intra-cluster and Client LANs
Shared Storage Cabling
HP NetServer LC 2000
Each node must be the same model SPU, but may have different size main
memory, cache, and CPU clock speeds.
Pedestal or racked
2
HP Rack Storage/12FC with 2 FCArray Cards, HP disks, and using a HP
D8602A HBA in the server. See Shared Storage below.
Any NIC that is HP and Microsoft approved. See
Embedded NIC with crossover cable. See
Client LAN
below.
Intra-cluster LAN
below.
Advertisement
Related Manuals for HP LC2000r - NetServer - 128 MB RAM
Summary of Contents for HP LC2000r - NetServer - 128 MB RAM
-
Page 1: Hp Netserver Lc
Microsoft Cluster Server. These configurations minimize single points of failure (SPOF), provide maximum availability, and have been certified by Hewlett-Packard and Microsoft. This guide is prescriptive; it describes the configurations supported by HP. Any deviance to these configurations can result in an inoperative cluster or an operating cluster with degraded performance, hidden SPOFs, etc., and... - Page 2 Power source Direct from power mains, power conditioner or uninterruptible power supply (UPS) using any power conditioner or UPS. System software: Navigator version L.18.02 or later Operating System Microsoft Windows 2000 Advanced Server Model HP NetServer LC 2000 Clock speed 733 MHz No.
- Page 3 FC Array Cards HP Fibre Channel Array Controller - D5990A No. of cards per cabinet 2 (Requires second card be installed in the Rack Storage/12FC) Firmware 4.64-00 or later Status SCSI ID 5 (fixed) Disk SCSI IDs 0 – 3, 8 – 15 (fixed) Disk drives: HP 9.1 GB (7200 rpm)Ultra SCSI Disk Module D6106A HP 9.1 GB (10k rpm) Ultra SCSI Disk Module D6107A...
-
Page 4: Shared Storage Cabling
Shared Storage Cabling This part of the guide defines the allowable cabling configurations for clusters using the HP NetServer LC2000 and HP Rack Storage/12FC. Only this cabling configuration and cables are supported. Fibre-channel HBA with GBICs 6-port Fibre-channel Hub with GBICs. The recommend port connections are as shown. - Page 5 Versions 16 May 2000 Corrected drawing. 11 May 2000 Initial release.