Preparing The Hp Netserver - HP D5970A - NetServer - LCII User Manual

Chapter 8

Preparing the HP Netserver

Before the HP Netserver can be mounted in the rack, you need to remove the
factory-installed chassis slides from the Netserver and install the flush-mount or
center-mount brackets.
1. Lay the HP Netserver on a flat surface.
2. Remove the slides from the sides of the chassis. See Figure 8-3.
Figure 8-3. Removing Existing Hardware
3. If you are center-mounting the HP Netserver, remove the center spacers
(attached to the chassis under the slides). See Figure 8-3.
4. If you are flush-mounting the HP Netserver, remove front bezel and the front
brackets. See Figure 8-3.
Do not remove the front brackets if you are center-mounting the HP
Netserver. In this case, the front brackets are needed to attach the bezel.
80
Rack Mounting the HP Netserver (2-Post)